Posted by jimg.allentown on January 31, 2020 at 06:36:46 from (24.115.193.250):
In Reply to: What Vehicle Can I Buy? posted by Traditional Farmer on January 31, 2020 at 04:10:17:
The USA has probably been in conflicts with every industrialized country in the world by now. That isn't the issue as I see it.
Isolationist policies were tried and found to be bad for the economy. Sending our jobs overseas is also bad for our economy. There needs to be some middle ground that is acceptable to the majority.
My biggest problem with "foreign" cars is the way it was when I was growing up and first began to drive. I had a Mercury Comet. When the fuel pump failed, I went to the parts store and got a new one for about $12.00. My dad had a VW beetle. When his fuel pump went bad, it cost $60 for a replacement. Labor rates for foreign cars at the time was more expensive. They were harder to work on and the parts cost more. What you got for the extra money was a poorly performing car that was uncomfortable to drive or ride in. No thanks!
The word foreign is inaccurate. Regardless of where the parts came from, most domestic makes were easier to work on. Parts were less expensive, and repair shops did not charge extra to work on them. That was good for a young man with not much money to spend on a car.
Enter the flood of cars from Asia and Europe, and the only thing they had going for them was they were cheap to buy new. They were also ugly, uncomfortable, and unreliable. Early Toyotas and Datsuns were probably the most poorly made cars I ever saw. They were tinny, ugly, and nearly impossible for a grown man to sit in, let alone drive. Also, they rusted out in minutes. The joke of the day was that they came from the factories with pre-rusted nuts and bolts.
Then there were some of the European cars. Renault, Simca, Sunbeam, Peugot, and Fiat. One of my earliest jobs as a mechanic was working in a multi-franchise dealer that sold and serviced those makes. What a collection of junk!!
You buy the car or truck that you like and I will do the same. Old habits die hard. I sill like a good old domestic make regardless of where the parts came from.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
