Posted by Jeremy in DE on January 30, 2020 at 08:06:35 from (174.200.28.105):
In Reply to: OT Cherokee speedometer posted by Jeremy in DE on January 29, 2020 at 07:30:59:
I'll reply here to say thanks to all who responded.
It's fixed now.
The problem was a bad ground, as some suggested. Previously I had suspected a bad ground, but the grounding locations I looked at all seemed good.
But after the replies I once again tried to trace the instrument cluster wires to their ground. I had been looking in the wrong place before, so no wonder I didn't find the problem.
This time I found the correct grounding point. It looked questionable. I tried to clean it up and a wire fell off in my hand. I suspected I had located the problem, but in any case I had to fix that wire no matter what. I did. Then this morning I drove it enough miles to be pretty certain it's truly fixed.
Just for the archives, this was the ground location near the dipstick.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
