It’s not illegal for home owners to do their own work or they wouldn’t sell supplies at the hardware store. Your best bet to jump off for power without a new breaker on your panel is either an existing 110v receptical or a light switch. You need a neutral to go back to the panel to balance any load safely and a live all the time hot for your vacuum to charge. On top of that you need a ground connected both to the outlet box and the ground screw on the receptacle. If you tap into a light switch , the white neutrals are likely wire nutted together so you’ll need to join in with that. If there’s no neutral at the switch at all (could be both a white and black on the switch) then the power is fed to the light then sent down to the switch then back up to the light. If that’s the case then you can grab all 3 needed lines at the light. If not then the hot feeding the switch will need to be unhooked, then make a 6” long jumper to refeed the switch and join that with feed you took off your switch and also with your hot going out to your new receptical. Use a set of pliers to tightly and neatly twist your wires together before putting the wire nuts on and make sure there’s no bare wire visible except your ground. All connections need to be tight,make nice neat hooks under your receptical screws not just jabbed underneath. If all of this doesn’t make perfect sense and is easy then ask a professional to do it for you. Loose connections cause arking which can cause a fire when your least expecting. Improper grounding can cause a potentially fatal shock to an innocent person. It might only be 110-120V but there can be enough current to kill.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
