Posted by Doug Wi on December 21, 2019 at 19:07:04 from (199.48.62.130):
In the corn rows. Up to 8" mud under that in too many places. And occasionally there is standing water between the two. Had good frost depth early on but it warmed up then snowed about a foot of heavy wet stuff adding more moisture and insulation. so frost mostly gone.Before deer season there was almost no deer tracks or sign in the fields. Now so many tracks they look like a barnyard. Moisture in the mid 20's with test weight in the upper 40's. Field I could go on today was no-tilled into sod so held up fairly well, but its a half mile off the road. had plowed a road to it earlier so that had frozen hard but still had to pull the wagons out with a tractor. Tilled fields are a no go until it dries or freezes through the snow. I keep telling myself and anyone else that will listen that we do this cause its so much fun. and questioning if I really mean it. But today was nearly 40 degrees, sun was out a lot, and everything worked. Had WVAL classic country out of Sauk Rapids mn on the radio and they played country style Christmas music. Corn stalks were tough yet brittle, too fast they would bunch up on the head. 1 1/2 to 2 mph top speed with the F2. Slow was faster. And you know with all the complaining we do today was FUN. we are blessed.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
