Posted by buickanddeere on December 14, 2019 at 07:20:04 from (67.69.69.78):
In Reply to: John Deere 1020 posted by jraylong on December 05, 2019 at 14:40:39:
At the very least plug both log splitter hoses into both ports on the SCV.
If the 2nd hose will not plug in. Either there is pressure on the tractor side or the log splitter side . Or the guts of the ports are stuck and need to move lengthways in the body. Tap with a hammer and proxy bar after soaking with penetrating oil.
As for the dealer routing the hydraulic oil directly back into the transmission case from the splitter . Next time you see him , give him a good swift kick on the a s s .
With an open Center plug in the splitter valve . The tractor closed Center hydraulics will be pumping max output at all times and running the front pump into cavitation .
Should not be too much of a job to route a second set of oil lines from the SCV to the other side of the loader lift cylinders .
This will supply down pressure AND prevent the hydraulic oil lever from being drawn low in the transmission .
Keep an eye open and even advertise on the local classified adds . There will be another loader around somewhere cheap with a joystick and a hydraulic bucket .
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.