BTO neighbor bought a brand new 560 diesel, hooked it to his mix-mill just minutes after unloading it off the dealer's truck. It ground a load or two of hog feed every day until the day many many years later it got unhooked to go to town for it's first overhaul. The little nubbins were still all over all 4 tires. Just about everybody around except Dad had a mix mill for hog feed. All our corn went through a Knoedler burr mill for cattle feed. My Brother-in-law's Dad had a hammer mill powered by a big electric motor for his hog feed, ground into a Heider augerwagon and hauled it to the feeders in the hog pasture. I was about 11-12 yrs old when I started pulling our Heider auger wagon 5 miles to town for ground feed every other day all summer and on nice Saturday's in spring & summer. 5500# was my normal load in the Heider, the mill's truck would haul 8000-10,000# and charge a Dollar or Two a Thousand for delivery, MY delivery charge was cheaper, about a Dollar for gas per load. The cattle ate every ear of corn we grew most years, all the ground hog feed was made from shell corn we bought in town.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.