Posted by Case Nutty 1660 on November 16, 2019 at 05:11:54 from (162.252.129.7):
In Reply to: Farming expense posted by John in La on November 15, 2019 at 17:14:55:
Ag tires along with all of these days are spendy,, I just had two 8 ply 750x 16 implement tires put on my W-5 loader yesterday to the tune of 386.00,, but the first pic here shows a tire off a 400 ton haul truck here,, couple of my friends from MI inspecting it, at the time a new one was just shy of 50K, when the tire in the pic was made it was 35K, I am not happy tire prices never really went back like they should beings the high oil prices from 5-10 years ago made them sky rocket. It got so bad here the local Coal mines started going to people they had sold the ones at the time that were damaged tot he point it was cheaper to replace than to repair back from the people at two to five times what they paid for them and built wind breaks with, the mine would come with replacement tires and swap them out at the ranches and hand them a check to boot, by the way they sell "junk" tires like this for 1200-1500 so you have a idea what they got back and still had the same wind break as before one of the haul trucks from that mine at work
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
