Posted by Texasmark1 on November 12, 2019 at 05:47:15 from (172.243.92.145):
In Reply to: Re: Snake Oil posted by Oliver 500 Wa on November 11, 2019 at 17:01:58:
MSDS says Naptha (for hygiene), Alcohol (for controlling small amounts of water in the fuel), and light mineral oil (for lubrication like would be required if atomized and shot into the carburetor of a 2 stroke engine to get it running, or determining why an engine won't start..... fuel related or ignition related......whereas starting fluid had no lube qualities required by 2 stroke engines, like Evinrude outboard motors in Wisconsin.....aka namesake Sea-Foam, ). I noticed some starting fluids today do advertise that they include lubrication.
There is a process called "Decarb" that is in the iboats boating forum archives, or just doing a www search of the word will bring it up, whereby you clean up a gummed up/carbon contaminated engine with Sea Foam. Testimonials all over the place about the process and that Snake Oil works.
Doing a www search on this topic: "Evinrude outboards and Sea Foam", brings up about 1,650,000 results...........must be something to it.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.