Tractor Talk Discussion Board |
Re: Re: gearing down john deere g 1948
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BJ on January 19, 2002 at 23:46:15 from (206.229.235.224):
In Reply to: Re: gearing down john deere g 1948 posted by Les on January 19, 2002 at 04:18:13:
I have looked into this on my 50' G and I don't think it is possible as the reduction gears on a G are wider than a 70 or 720 (if I remember correctly) and also the gear on the input shaft of transmission on a G has very little clearance between the outer diameter and the reduction cover. I did do a gear reduction on a 70 gas a few years ago by taking a set of reduction gears from a 70 diesel and using them I had to bevel the inside edge of the pulley drive gear to provide clearance between it and the PTO drive gear that runs beside it on the crankshaft and also had to remove the oil slinger gear that rides on the pin at the bottom of the gear reduction cover I then overfilled the transmission by about 2 gallons to insure that the reduction gears would still be getting lubrication I used it for pulling and plow days with no adverse affects
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|