Tractor Talk Discussion Board |
Re: Re: Re: Re: Re: New Toy for the Tractor Forks
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Grove r on January 19, 2002 at 11:43:23 from (161.184.17.203):
In Reply to: Re: Re: Re: Re: New Toy for the Tractor Forks posted by Mark Hendershot on January 19, 2002 at 11:25:28:
That sounds just great! I, to, had to widen the fork carreir, was just too narrow for what I was doing. The mast and forks were originaly off, I suspect, a warehouse machine, for four foot wide palletts, and only had about three inches of ground clearance. The forks were cut back to three feet long, was going to lengthen them, but found they were OK for my use. [Mounted a grapple to hold the round bales and sometimes logs to]. I did lengthen the verticle eight inches to give me eleven inches of ground clearance, and there are times more would be nice. Kind of hard to explain how I widened the fork carrier. If you would like to see a picture, go to ibdozing.com and look under the "archives" section.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|