Nah , many years back like 1977 my buddy and i poured the floor in his new 40x72 , just he and i from the wall to the edge of the big door it tapered fro 4 inches to 8 inches and down the center it was eight inches thick with wire all the way across from the walls to the door we started off mixen ourself and pouring a little here and there and had about half hand poured before we said enough was enough . He and i cut a deal with the local cement place that we would haul them two big loads of sand a day in the evening when we came home for concrete as he and i ran coal buckets and came by the sand and gravel plant each night on the way home . So the deal was struck and we had a 6 1/2 sack mix bought out . we formed up half way down the middle and he and i poured over 32 yds the one day and Hand finished it and that evening pulled the forms and the next day it was a 30 yd pour . four days later myself my buddy and his brother backed in our three coal buckets loaded with his brother being the lightest at a 119 and change and Mike and i being 126 128 and change . and to this day there are NO cracks in that floor , it was put down ontop of 6 inches of 57 slag and wire and LOTS OF BEER CANS , Beer cans are the secret . Many 120000 lb plus loads were placed on that floor.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
