Tractor Talk Discussion Board |
Re: Re: Hyd. Seal Installation tool??
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Don on January 05, 2002 at 10:46:17 from (208.16.93.216):
In Reply to: Re: Hyd. Seal Installation tool?? posted by Scott ks on January 04, 2002 at 17:28:12:
Thanks for the info. At present getting a page not avaliable from that site. But O rings are not what I'm dealing with here. These seals are a stiff, square edge affair that are a bugger to bend. The tool I'm looking for has 3 fingers that bend a deep U shape into it. This decreases the overall Dia. so it will slip down the bore. Once in position the levers are released and the seal is slipped off the end of the tool into the groove. Don
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|