Tractor Talk Discussion Board |
Re: Does anybody know a good way to...
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Brian on December 09, 1998 at 17:42:05:
In Reply to: Does anybody know a good way to... posted by Levi on December 09, 1998 at 14:13:33:
The machine shop should have boiled the block. This should remove everything from inside of the block. You should ask if they did this. If not you will have to take it back to be done. If there is still rust falling out then there may be oil passages that are plugged. This would starve the engine of oil, causing you to have to re-rebuild the engine. I hope that this is helpful. Brian
Follow Ups:
Post a Followup
|