Tractor Talk Discussion Board |
Re: timing
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill from up north on December 29, 2001 at 06:48:12 from (205.200.30.77):
In Reply to: timing posted by peter on December 27, 2001 at 09:03:38:
First of all, You should check the point setting with a dwell meter -much more accurate than trying to set them with a feeler guage. Point setting affects timing. The narrower the points are set the more the timing is delayed, so there is no use in checking the timing until you know the points are exactly where they should be. The best way to set the timing (in my opinion) is when the engine is under heavy load-hooked up to a dyno is ideal. Where ever it has the most power (and it will run the coolest) is where the timing should be -regardless of what "The Book" says!! Why--Because Book specs. are based on a particular fuel grade at a particular altitude and the higher the fuel grade the slower it burns, therefore requiring more advanced timing, plus fuels have changed over the years. Have a good one!! -Bill from up north
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|