Tractor Talk Discussion Board |
Re: How to remove stumps
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob Kerr on December 22, 2001 at 21:40:04 from (152.163.213.212):
In Reply to: How to remove stumps posted by Sonny on December 22, 2001 at 18:55:17:
Splitting stumps is tough tough tough work. He might have been pulling your leg just to see you sweat. That wood is so twisted together where the roots spread out you would be lucky to get an axe ito it without it bouncing out, or just sticking in so hard you break the handle pulling it out.I had a neighbor stick a steel wedge into a stump so far he couldn't get it out and the stump wouldn't split, so he had to burn it out and it ruined the wedge. Before the world went nuts you could get hold of the local extension office and they would give you the formula for ammonium nitrate and diesel fuel to blast them out cheap. Since OK City, that stopped.Most mines use that formula now instead of dynamite, maybe one of the guys there would help if there is one near you. Don't try it on your own without knowing how. Your wife may have to trade in the casket for a dust pan and broom.
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|