Tractor Talk Discussion Board |
Re: clutch wont disengage
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mark Hendershot on December 19, 2001 at 16:10:35 from (216.166.150.156):
In Reply to: clutch wont disengage posted by Gene on December 19, 2001 at 15:36:17:
Check to make sure the clutch pedal only goes down 1/4 to 1/2 in. to take up the slack befor starting to disingage the clutch. Also if the pedal is adjusted correctly, the disk might be frozen to the flywheel(if cold enought) if warm then maybe rusted but you should be able to brake it loose buy driving it. If the pedal goes down with out any forse needed it might have got loose (the bolt that clamps it) Need more info dose the pedal go down? ECT. Put it in 4th gear while the engine is off and rock it while someone holds the clutch pedal down that might break it free. Mark H.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|