This past July 4th three of our granddaughters came to stay with us for a couple days and they brought along their four little ankle biter dogs. Three of them were the size of a medium sized cat. I like to sit on the recliner with a firm pillow on my lap to rest the Ipad on. Eventually two of the little dogs ended up on my lap enjoying the pillow. What I didnt know is these two dogs dont get along with each other very well. I was enjoying petting them when the smoke alarm went off. Someone burned some food on the stove. The screech of the smoke alarm set the two dogs off and in a flash I had a snarling, growling, biting, ball of brown fur going around in circles on my lap. I didnt want to get caught up in the fracas so I shoved them off on the floor and I swear they were still going around in a snarling circle on the way down to the floor. When they hit the floor they REALLY went at it till one of the granddaughters broke it up. A little while later they were going at it in the bedroom so one of them was put in a kennel upstairs for a time out.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.