Tractor Talk Discussion Board |
Re: adding a second hydraulic controller to a 1963 ford 4000
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JK-NY on December 15, 2001 at 10:31:25 from (209.240.222.130):
In Reply to: adding a second hydraulic controller to a 1963 ford 4000 posted by Will Wyatt on December 12, 2001 at 15:06:46:
If your tractor does'nt ae a remote hyd. valve and you've tapped theaccesory plate under the seat on the right side of the tractor you will have to chain the 3 pt lift arms a little bit short of being all the way up then oil should go to the loader valve. There were factory and aftermarket remote valve made for these tractor, some had power beyondcapabiity,some did'nt Also a selector valve made to give either 1 way remote hy or 3 pt. My NA A has one of these, now that I think about it I,m not sure if these were aval for the newer models or not.I would see how the person you got the loader fromhad it plumbed up if itwas a similar tractor. f you need a plate or valve maybe he cold help.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|