Tractor Talk Discussion Board |
Re: Re: Re: Re: Re: Steam whistle air pressure?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob Kerr on December 13, 2001 at 17:34:50 from (205.188.193.33):
In Reply to: Re: Re: Re: Re: Steam whistle air pressure? posted by Hugh MacKay on December 13, 2001 at 15:42:09:
I have a steamboat and one nice summer evening I finnished up testing the boiler, before an antique boat show,and put in a small fire and brought the pressure up to just 20 lbs. By this time it was about 11PM at night and all was quiet. I gave the whistle cord a tug and the echos that came back were astounding!The last one I heard came back about 15-20 seconds after I blew the whistle.I heard the echos coming back from many different directions.It sounded so neat, I was floored! I did it several more times before I thought I would get the whole countryside awake. The land there is not in a valley but is almost perfectly flat and the sound must have bounced off of grain elevators, water towers, silos, barns and the like.The sound that returned came back sounding excatly like it did when I blew the whistle and wasn't mixed in with any other echos like you get in a valley. You could have swore there were 8 other guys sitting out there in the blackness with a steamer blowing their whistles as a hello. It was almost worth charging admission! If I had the full 80 lbs in the boiler I would have charged admission! The next day I asked the folks down the road if I bothered them and the said they never heard it. They were kind of bummed they didn't hear it as they haven't heard it yet and the only time I ever fire up the boiler is at a lake 15 miles away. Maybe the echos I heard were the ghosts of all the old traction engines that were in the area years ago saying hello!
Follow Ups:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|