Tractor Talk Discussion Board |
Re: Re: Homemade Tractor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by snitkawl on December 11, 2001 at 16:10:16 from (64.216.158.60):
In Reply to: Re: Homemade Tractor posted by John on December 11, 2001 at 14:36:49:
OK, I`m ignorant. I use a Cummins diesel to power my sawmill. In order to make it function properly I have to have an extra part put on the fuel system. Without that part it acts just like it doesen`t have a governor. When you put a load on it, it falls on its face. When you install that part and put a load on it, it picks up the load just like it had a governor on it. I also have a log truck, powered by a 350 Cummins, with a Hood loader on it. It needs the same type of part on the fuel system to function properly, as the engine on my sawmill . So, my question to you is, if diesel engines have an internal governor installed at the factory, why do I have to spend in excess of 500.00 dollars to have this part installed on my engines? Could it be that what you are talking about is the device that keeps the engine from overrevving?
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|