That kind of repair is certainly well earned in the heat and humidity while in standing corn. Why is it that machines like these always seem to have a serious mechanical failure in places like that ? I'll bet there are even worse places and conditions. Like a crawler throwing a track while in a turn on a hillside in mud. Not something you can walk away from, best to get after it right away like you did, whenever possible.
Long time farmer friend had a bearing overheat in his 6620 combine during harvest, back side of a field, down hill, against a hedgerow and marsh like area. Tough one to get to. They were able to quell it before a fire got out of hand, apparently this grease fitting was not known about and he had this 6620 for many years, so not really sure what happened. With him overseeing, due to health issues, I used to thoroughly grease this combine, even repaired the header auger, put all new sections on the sickle bar, guard extensions for downed oats. I thought it was well taken care of and we left it ready for corn after oats. Apparently under the operator station, there is a fitting that often gets missed. Recall he had all the books, but that was an expensive repair, thankfully he did not lose the combine to fire.
That is something, high enough clearance to apply at such height, should definitely pay off. I rode with a person running a late model JD sprayer on all the fields he planted in 2009, about 300 acres worth. This thing was amazing and I have photos somewhere, one of the little car I used to drive, parked right underneath it, drove it under to get the shot. That thing had no suspension, remember how it handled when going over a ditch. Seemed like you could run in corn until it was pretty high, thinking about this now.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
