There is a huge pile of those mill drills sitting in shops and garages collecting rust and dust and there is a reaon for it. Personally you couldn't give me one if I had to use it to make parts. Am a machine tool snob? Maybe but taking half a day to do an hour job and getting it close but not right does not suit my personality.
Three reasons not to own one, maybe 4, or maybe 5. Number 1- the primary issue I have with them is the reason I own a mill which is to make flat cuts on a work piece and end up AT A GIVEN SIZE measured in .001 increments. There no way to do this on a mill drill unless you add scales to it on the quill and good luck. After you add the scale and spend forever getting it set where you want it make a cut and report back how close you got it. Number 2- by the time you add a chuck and vise there isn,t enough distance between the quill and table to use it for anything but smallish parts. Number 3 it is very likely a step pulley drive, wouldn't have one in the shop unless it was converted to VFD,, more $$ to spend. Number 4, not enough table movement to work on anything but small parts. Number 5 they take up space in the shop while rusting away until you find a buyer. I WISH that somebody had made these points to me in a direct manner before I made the mistake of buying one. I now own a 9x49 knee mill.
Bottom line is a mill drill is OK if you are building models or working on parts that are the size of an egg cartom AND you have lots of time and patience, otherwise get knee mill, lots of them for sale used and new.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
