Posted by Lamont in NC on June 21, 2019 at 08:28:56 from (45.36.228.199):
I'm curious how small engine shops and others who do a lot of small engine repairs handle oil changes. The drain plugs on pressure washers, push mowers, generators, tillers etc are never in a place for easy draining w/o making a mess. Even excluding the oil running all over the equipment they are rarely made in a way I can get a catch basin under them. There has to be a better way.
Yesterday I grabbed an old 2' tall 18" x 36" plastic shelving unit to use as a work table for a pressure washer. When I changed the oil I let it run out across the frame of the washer (couldn't do much elseJ) then through the shelf and I put a oil catch pan on the shelf under it--worked quite well. Today I had the bright idea of putting that shelving unit on wheels and putting it to use like this more often. I was a bit concerned about how much weight it'd handle so I sat on it and found it holds less than 160lbs the hard way. In fairness it was a section of shelving that had been left outside for a couple years and was brittle from sun exposure most likely.
Before I create another project for myself making a table I can drain oil, gas etc directly on and have it run to a container I'd like to hear or see some setups that might work better or just as well and not involve me getting started on another project.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
