Tractor Talk Discussion Board |
Re: choke problems
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by T.C. in Tx on June 12, 2007 at 06:36:28 from (70.116.31.231):
In Reply to: choke problems posted by JS inMC on June 12, 2007 at 03:43:22:
I had a similar problem on my IH 2400A. It wouldn't run without the choke being pulled out about 3/4 way. The problem seems to be solved now. What I did was pull the carburetor and thoroughly check everything. Two things could have been a problem. This is a Marvel-Schlabler carb. The ventura tube may not have been seated right. But the gasket holding the carburetor to the manifold looked suspect. I made a new gasket and used a file to be sure the surface was flat and clean on both the carb and manifold. Problem solved. In short if you have to use the choke, you have a vacuum leak somewhere.
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|