Tractor Talk Discussion Board |
Re: Re: 8n runs rough and smokes
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gary on November 25, 2001 at 16:34:31 from (209.23.132.16):
In Reply to: Re: 8n runs rough and smokes posted by jakee on November 23, 2001 at 20:39:41:
Thanks for the tips. I did mic the cylinder walls (top/bottom and same at 90degrees) All measurements were within .003 of being in spec. The cylinder walls were honed before installing the new piston rings. The gap of the piston rings was checked before the rings were put on the pistons and all were not more that a .010 gap. Still trying to figure this out. Dont know if the rough running is a differant problem from the oil on the cylinde top or not.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|