Posted by oldtanker on June 05, 2019 at 19:50:03 from (66.228.255.203):
In Reply to: 14" 2 bottom plow posted by 3/9semfi on June 05, 2019 at 05:39:19:
Quoting Removed, click Modern View to see
OK look at it this way.
1: If the tractor is indeed a 9N the newest it could possibly be is 1941. So the selling is either ignorant about the tractor or lying.
2: West MN an perfect show ready fully restored 9N with new tires might bring 2500. Average condition maybe 1300.
3: What type of mower? New 4' ruff cut from Fleet Farm is 1050. New disk about 1,000 and new blade 400. Used used ruff cut about 500 at best, 600 for the disk and 150 on a used blade.
So...
1300
500
600
150
2550 or so? You can add another 1000 if it's a used finish mower in good condition.
Just don't want to see you pay more than it's worth.
The prices I mentioned before of 1800 and 1050 at an auction last month was near Perham MN.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
