Posted by JohnV2000 on June 05, 2019 at 14:22:20 from (71.61.100.67):
I noticed that after clearing my fuel line, my tractor seemed to sputter a little bit while idling.
I read though my Super C manual, and it described how to set the idle screw. I turned the idle screw all the way in, then backed it out one full turn, per the instructions. I screwed in the throttle stop screw a little bit so it would not stall at slow idle speed.
I closed the throttle all the way and backed out the throttle stop screw to slow down the slow idle speed to a reasonable level. I also tried adjusting the idle adjustment screw, but no matter how I adjusted it, it would not idle smoothly.
The manual says that a small adjustment of the idle screw should let it run smoothly, but I could not get it. I eventually set the idle screw about one half turn shy of all the way in, and I had to choke the tractor a little bit to get it to run smoothly. Once choking it, it idled smoothly and ran better, but without the choke, it will not run smoothly.
I assume this is another opportunity for me to learn about tractors, and carburetors specifically.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
