|
Tractor Talk Discussion Board |
Re: Re: Bolens-Iseki-FMC G174 4X4 w/1517 Loader
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Whitebeard on November 22, 2001 at 09:23:50 from (208.157.60.51):
In Reply to: Re: Bolens-Iseki-FMC G174 4X4 w/1517 Loader posted by len on November 17, 2001 at 20:59:45:
I own a 1986 Bolens (Iseki)G214 which is probably similar. It's 21 hp, 3 cyl, diesel, 4 wheel drive with a back hoe and FEL. I've 1100 hrs on it. It is a well thought out machine and built with quality.It has the easiest starting, smooothest diesel motor I've ever owned. There is a 540 & 1000 rear PTO, 6 forward 2 reverse with a high and low range (12 & 4) I have a kit for a live PTO off the front of the engine I never installed ( I leave the FEL on). Fortunately, my unit is exactly the same as a White Field Boss 21 and parts are available through AGCO. The current MF 12xx series are Isekis. Bolens was taken over by Troy-Built ~ 13 years ago, they became Garden Way that just was acquired by MTD so I'm unsure of parts availability with them. I had to buy a water pump from them ~ 1996 at $235 and felt I was GOUGED. I should have sent it out for rebuilding. Also the boot around around the gear shift lever and a big rubber gasket where the shift linkage enters the tranny deterioted and water got in the transmission. I got parts through AGCO for that. I've done alot of work with this set up. The FEL was built for Bolens in Fort Erie Ontario and is bullet proof. It has a heavy- duty bucket with a rounded back that is perfect for back grading. The back-hoe is Bolen badged and also has never given me a problem. I have the parts and owner's manuels. Isekis IMHO are quality machines, the Bolens attachments I have are well built. I'd be worried about MTD supporting parts but could be wrong.Len Sheafer in Rockford IL. as in above post is a good resource.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
