Posted by rrlund on May 14, 2019 at 09:35:19 from (69.36.62.180):
In Reply to: Re: Roundup? posted by Bruce from Can. on May 14, 2019 at 07:40:55:
Same here Bruce,but it's the whole principle and injustice of the thing. A group of people who are opposed to some practices have found a name and a product to villainize. If they accomplish their goal,they won't stop,they'll just go after something else,and the next time,it might be something that I do depend on more heavily.
Glyphosate was a Godsend for me until we managed to eradicate that scourge called quack grass because of its massive root system,but now that it's gone,fine and dandy,these other grasses can be handled with atrazine. I use glyphosate on first year corn. I plow down alfalfa sod,wait 30 days and hit it one time with Roundup. I could probably just as well clean it up with a pre emerge shot of atrazine,but Roundup is safer and more thorough.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.