Posted by Steve@Advance on April 30, 2019 at 11:43:05 from (24.182.105.179):
In Reply to: 610 kawasaki mule posted by Dale2 on April 30, 2019 at 10:46:00:
"Most" sensors with a single terminal provide a ground for the circuit.
On an over temp sensor, typically the sensor is open when the temperature is below the danger level.
A simple test would be to remove the wire, the light should go off. Then ground the wire and the light would come on.
If the light goes off, and the temperature is not high, the sensor is bad. If the light stays on, the sensor wire is grounded somewhere, pinched, burned, mouse chewed, somehow it is getting a ground.
If it is a 2 wire sensor, that will usually make the connection between the terminals to turn on the light. It can be tested with a jumper wire across the terminals.
I'm speaking in generalities here, so anything is possible with today's electronics. The signal could be passing through a computer module, so it can get complicated. A shop manual with wiring diagrams would have the answer.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.