Posted by Destroked 450 on April 29, 2019 at 18:35:03 from (66.38.93.182):
In Reply to: DIY my own non-ROPS posted by WorkingDad on April 29, 2019 at 17:11:23:
250C is a industrial model of a 4610 ag tractor.
ROPS for a 4600, 4610, 3930, 4630 will all fit, you should be able to find one.
One can build a suitable ROPS using the proper material, I have one older rigid and one folding ROPS.
Both use 1" thick base plates mounted to the axle with 4 - 3/4" bolts thru the stabilizer bracket and a 3/4" flat bar.
6x2 box tubing 3/16 wall fully welded to the base will work for the uprights, a small hole drilled near the bottom on the 2" side allows any moisture to drain.
The old rigid has a 4" schedule 40 pipe going thru and welded to the uprights.
The pipe is also filled with sand to prevent it from bending.
Can't say how much it leans back or the height without taking some measurements.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.