Posted by T.C. in TX on April 22, 2019 at 18:51:36 from (76.210.188.105):
In Reply to: Shop Question posted by knightstead on April 22, 2019 at 15:01:09:
Here is my experience. I built a shop in 1996 and used the "bubble wrap" stuff with white plastic on one side and reflective aluminum on the other. All was fine for about 10 years and the stuff started coming down. Basically it had just turned to very brittle material and if you touched it, then it would crumble.
Well by now I had a lot of wires, plumbing, you name it up in the ceiling. Bought some 4 inch styrofoam and had had a contractor install that. Made a big difference. Couldn't go with spray foam because of the mess it will make during the install with the particles that fall during application. Would not have been able to cover everything well enough.
Meanwhile, I have a 2,500 foot uninsulated work space attached to the building. It was unbearable in the Texas heat. So, I went with the closed cell spray foam insulation there. The difference is dramatic. I measured the bare tin in mid day at 152 degrees. Right next to it where the insulation had been sprayed on it read 99 degrees--only l degree above ambient temperature.
No doubt in my mind, any future construction gets the spray foam
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.