Tractor Talk Discussion Board |
Re: Hyraulic Cylinder Question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gatractorman on October 23, 2001 at 17:11:33 from (4.16.152.168):
In Reply to: Hyraulic Cylinder Question posted by Nick G on October 23, 2001 at 09:40:22:
I'm assuming the tractor is still running when the boom is drifting down (normal for some drift when not running) Rick could be right on his post but has been my experience if using that kind of packing usually have 2 sets one seals one way and one the other its not hard to check the cylinder (just a bit messy) raise the boom determine which line on the cylinder is being used to raise it (usually is the one on the bottom but i have a 2544 Int. and its cylinder is upside down) anyway remove the opposite line from the cylinder be careful and make sure you have the right line, start the tractor and try to raise the boom in other words bottom the cylinder out and see how much oil if any you have coming out of the cylinder where you removed the line some is normal if you get a full stream cylinder packing is bad, but it would be my guess that it would be a port relief seal anyway since it doesnt drift when you have the tractor raised up. Sorry for the long post its just this is what i do for a living and i try to help.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Proflie: John Deere Model R - by Staff. The John Deere Model R, the last of the lettered tractors, was the first diesel-powered tractor produced by John Deere with a gasoline starting engine. It was also the first tractor they produced that had an optional steel cab. The photo above shows the tractor w
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|