Posted by redforlife on April 01, 2019 at 08:18:28 from (68.234.121.189):
In Reply to: 2wd on a slope posted by kmacht on April 01, 2019 at 07:35:21:
Being farmed back in the 50's is not why the soil is loose in present day. Its because of years of being covered and shaded by trees and years of leaf debree being deposited. I don't think a 4wd is what you need. Will just help you get around further and tear things up even more.
I suggest you cut and fell the trees down. Anything to just get them down, and spray the stumps. Then start working on the down trees from the outside in. Being on sloped ground, there should be good run off when it rains. Standing trees hamper this. And the ground needs hit with sunlight to dry it out. I wouldn't worry much about working the ground or seeding grass untill it is completely cleared. Even after trees are down, only use tractor when it is dry. Tree clearing is very detrimental to the ground with equipment travel. Probly not going to salvage any grass that is already established there in the beginning. You just got to deal with these problems when clearing trees.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.