If any of you haven't worked on a 3 cyl Ford tractor engine, let me just put out there that of any I've worked on, they are the biggest pain to work on the carb or ignition. Everything is wrapped around everything else with no room to maneuver without removing a bunch of stuff that doesn't even really help much.
I for one aren't big on draining the carbs dry anymore. Seems like the newer gas will absolutely dry out every gasket, seal, o ring inside that carb now after it's drained out. Not such a big deal on a tractor, but it's a pain on my motorcycles that have 2, or 4 carbs that are a pain to remove when they have problems. And with all the rubber parts in them, they'll shrink right up after the gas is drained out, at least in my experience. For that reason, on all of my bikes being put up for winter, I drain the tanks, drain the carb bowls, put the tank valve on reserve, and pour about half a quart of diesel in the gas tank. Just enough that it will fill the carb bowls. One thing about motorcycle carbs, they are designed to be drained easy. In the spring, I open all the carb drains, let the diesel out into a pan, fill it with gas until it runs out the drains, then close em up. Good to go, never had a problem doing it. Just always got tired of having to fish the carbs out every year because they o-rings dried up without liquid against them, or the carb gummed up from leaving the gas in it. The carb bowl o-rings I had to buy for a bike I just bought that had been setting were a steal at $15 on ebay for for the 2 o-rings, normally $22 each. I'm sure seafoam would probably work, never had any luck with stabil, but I just use the diesel, it works for me.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
