Posted by Dan in North Houston on March 25, 2019 at 08:35:02 from (216.136.87.146):
I spent Saturday repairing damage to the hay fields. For those of you that don't have feral hogs, you cannot believe the damage they do. I lost about 5% of my hay crop last year. They are too smart to successfully trap. Neighbor has one of the fancy traps that sends a video to his cell phone, so you can trip the gate at the best time to catch the most hogs. He has taken over 300 in 3 years, but then are getting smart to it. He started out catching a dozen at a time, now it is just the occasional single hog. You can't hunt them fast enough, and you'd have to stay out all night every night. Problem is, they can range 5 miles a day, and they might be back tonight, or you may not see any sign of them for months. So I thought it would be interesting to see how other people repair the damage. I disc, re-seed, and the run a roller packer over the ground.
First photo shows typical damage. They root holes about 6" deep, although occasionally they can be a foot deep or more. The strip in the back is where I've made a pass with the disc.
When the grass is short, I pull a chain harrow with the spikes down behind the disc. If the grass gets much taller, it will roll up in bunches under the chain harrow, so I won't use the chain harrow much longer, unless after the hay is cut.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
