Tractor Talk Discussion Board |
Re: CaseOmatic 610
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gene Olson on October 12, 2001 at 13:21:05 from (12.75.133.198):
In Reply to: CaseOmatic 610 posted by Dave on October 11, 2001 at 09:50:18:
Dave Jack up the rear end with both wheels off the ground. On the brake housing there is a pull rod attached to the brake pedal arm. Tighten the adjusting nut until you feel a slight drag when the tire is rotated. Then loosen the adjusting nut 3 turns and tighten the jam nut. Do both sides and check to see that both set with the interlock in place on the pedals. If not, adjust accordingly. On the case o matic when you release the clutch the drive clutch is hydraulically engaged. It will not feel like a clutch with the pressure plate. Gene
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|