Tractor Talk Discussion Board |
Re: Re: Re: Another oil furnace question - where's the air come from ?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Drill on October 07, 2001 at 08:35:26 from (161.184.180.128):
In Reply to: Re: Re: Another oil furnace question - where's the air come from ? posted by Amateur Mechanic on October 07, 2001 at 06:29:57:
The tub that the oil runs into should have a row of holes drilled all around the tub about a inch up from the bottom. Over the years these probably have become pluged. Your only recourse is to take the tub right out and clean out these holes, you may even have to redrill them if the carbon is to hard. It's a dirty, nasty job but somebody has to do it. Hope this helps. Drill
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|