Tractor Talk Discussion Board |
Re: Hydraulic Cylinders on Loader (Need Advise)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tom Thal on October 05, 2001 at 17:16:45 from (162.42.198.210):
In Reply to: Hydraulic Cylinders on Loader (Need Advise) posted by Jim (Mi) on October 04, 2001 at 09:21:07:
I might add my two cents on this question because I have gone both routes, I have used new Prince rams and rebuilt my originals. The question comes down to the condition of your rams. If they are as decent as you say they are give rebuilding a shot. I had to heat the seals up in boiling water to make them pliable enough to roll over a ridge on the hydraulic piston but it worked great. The seals are often direction specific but the hydraulic parts guys are "usually" good enough with advice. Prince makes some decent stuff also and parts are available from Northern. I built and still use a backhoe with Prince rams. good luck!
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|