Tractor Talk Discussion Board |
Re: How do I remove a outer bearing race from a transmission housing ???
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ferrell freeman on October 03, 2001 at 14:45:07 from (158.252.69.143):
In Reply to: How do I remove a outer bearing race from a transmission housing ??? posted by Alberta Mike on October 02, 2001 at 20:28:04:
Mike, you might try a bearing separtor and puller it goes around the bearing race . This unit can be rented from most tool rental places. The unit uses a bearing separtor which goes around the bearing or race and tighten down ,also two rods or bolts that connect to a flat bar type bolt puller.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|