Tractor Talk Discussion Board |
Magneto won't ground out - A QUESTION ???
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Alberta Mike on October 01, 2001 at 18:53:22 from (209.47.89.104):
I've got a 4 cylinder Wico magneto here that will not ground out (using the external grounding post) when you want to stop the engine. I pulled the mag cap off and I see attatched to the inside of the grounding post (which is insulated from the mag case), there is the remnants of a wire (actually a thin flat metal strap) that once went somewhere but has burned off. I cannot tell where it went to. This is obviously why I couldn't ground out the ignition system to stop the tractor engine. My question is, where is this wire (strap) supposed to go to on the inside of the mag so I can ground out the ignition?
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|