Tractor Talk Discussion Board |
Re: Re: Removing and Installing Rear Tractor Rubber - How's it done ???
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Grove r on September 21, 2001 at 16:13:05 from (161.184.22.61):
In Reply to: Re: Removing and Installing Rear Tractor Rubber - How's it done ??? posted by Dave_D on September 21, 2001 at 14:13:38:
Hi, Dave, good advice from everyone, have changed and repaired more tires than I can count, and I don't own or work in a tire shop! Have changed/repaired tires as big as 18.4 X 38, with fluid, and didn't need a pump for the fluid, in or out, let gravity and a little time do that! Explained how on an earlier post. One thing I would like to add about breaking the bead, I use a 2 1/2" piece of 2" angle iron and an 8# sledge, [this is with the tire on the ground], place the angle iron on the tire with both lips on the tire and one against the rim. strike the angle so as to drive the one lip under the rim, forcing the tire down on the rim. this might take awhile, depending on how hard the bead is stuck, just keep moveing along a bit after each strike. I use a large hammer to reinstall the tire on rim after repair, but be carefull to just hit the tire bead. If you like I can go into greater detail if you E mail me Have a gooder, R.E.L.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|