Tractor Talk Discussion Board |
Re: Delco generator voltage change over.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Lew on September 15, 2001 at 20:17:41 from (207.190.82.58):
In Reply to: Delco generator voltage change over. posted by Mr.B~MI on September 15, 2001 at 11:29:00:
Can't speak to your regulator situation, but I converted my Case VAC to 12 volts by replacing the cutout with a solid state diode (50 amp) and control the rate of charge by resistance in the field circuit. The VAC used the 3 position headlight switch to control charge so I moved the light control to a separate switch and use the old one for 2 position charge control. I also changed the ignition coil to a 12 volt one. This was done in 1982 and all is still well. Kept the 6 volt starter and keep the engine in good tune so it starts quickly and doesn't cook the starter (double voltage means double current hence 4 times the wattage). You could use the cutout part of the regulator and insert some current limiting in the field circuit. Might be fun to play around and see what happens. Keep us posted. Have fun.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|