Posted by paul on February 18, 2019 at 08:42:28 from (174.219.12.211):
In Reply to: Off Topic- Daytona 500 posted by Steve A W on February 17, 2019 at 22:00:13:
I miss the good old days.
When areodynamics kicked in big time to make the cars stick to the track in the 70s perhaps, into the 80s, the big high banks super speedways became a problem. The faster you go the more you stick to the track on them. So you just keep your foo down and you go faster and faster. But there has to be -some- bit of safety and control. On a normal track it is the corners that you have to slow down.
The high banked 2+ mile tracks, you don’t.
So, restrictor plates and other stuff has to be used to create what ends up being a boring single file follow the leader or group up in a pack race. If you pull out by yourself you don’t have enough power to do,anything but fall backwards. If a group of you pull out to pass it requires such close quarters to keep the speed up that someone gets in trouble and wipes,everyone out.
The nature of the beast.
There is no good way to fix it.
They would need to go back to racing stock cars with stock sheet metal so the cars don’t suck down onto the track; but they still would go too fast to be safe and need modifications and end up getting different sheet metal and..
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.