Posted by caterpillar guy on February 07, 2019 at 06:37:09 from (47.26.86.124):
In Reply to: Building size? posted by Lazy WP on February 07, 2019 at 05:16:04:
Do you have a tall fearing on the top of the truck. A grain trailer is only about 10 foot high and the truck would normally fit in a 12 foot door. Mine will go under 12 foot doors with the dump trailer. The dump trailer is higher than the truck by just a wee bit. You could make the building narrower, then with a taller building like 16 feet the lean to could be wider with still 12 feet under the eaves for the tractors. Third option make the building long enough to get the trailer in to work on and then put the truck in separately to work on. If you don't make the building long enough to back in unhitch and work around them both you will always wish you had. After all do you not want to open the door just to grease the fifth wheel then have to close it again after you hitch it up again. Changing rearend oil is not handy from under the trailer either. This would now be about 90 feet long. or about 60 feet wide for your requirements.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
