Tractor Talk Discussion Board |
Re: Re: Using left-handed drill bits - A QUESTION ????
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Alberta Mike on September 03, 2001 at 17:05:06 from (209.47.89.100):
In Reply to: Re: Using left-handed drill bits - A QUESTION ???? posted by Robert in W. Mi. on September 03, 2001 at 15:55:20:
The washer sounds like a good idea and actually, I'd like to try the welding thing but I don't think I've got enough bolt sticking up from the engine block to weld to (without getting a bit tight). I'll check it out the next time I'm out where the tractor is stored. Sounds like the welding the nut on thing is a bit more likely to work as opposed to the easy out thing. Thanks for the help.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|