Tractor Talk Discussion Board |
Re: Dearborn Mower 14-15A sickle bar.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tom-Pa on September 02, 2001 at 13:24:22 from (65.14.179.38):
In Reply to: Dearborn Mower 14-15A sickle bar. posted by Old Fart on September 01, 2001 at 17:38:37:
You will need more than just the axle bracket. You will need 2 ea 8" extentions for the vertical lift rods between the upper and lower lift arms, and a bracket that attaches below the toplink attach point. The 14-15 series and 14-16 series do not attach to the toplink itself. nomenclature................P/N toplink bracket.............141262 bracket & Ball assy.........141186 lift extentions.............142712 I made my lift extentions out of 3/8 pipe 'T' and 7" 3/8 pipe. the 'T's' are installed so centers are 8" apart and are 90 degrees from each other. I had to hunt around and finally found the two brackets at old farm equipment dealers on tractors and bought them as i had the mower(14-16) that used them.. If you want the manual and master parts book you can get them from the N-Newsletter archives..I have link below Good luck Tom-Pa
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|