Posted by Bruce from Can. on January 26, 2019 at 08:46:55 from (74.12.71.182):
In Reply to: Barnyard surprise posted by tomstractorsandtoys on January 26, 2019 at 08:34:38:
This doesn’t add up for me. If your wife found a dead calf in the pasture in the last week of August, and this new calf born yesterday to cow number 2. Tells me that for the dead calf in the pasture to have been a twin of the live calf you have now, both born to cow number 2 , the calf in the pasture wouldn’t look like much, being nearly 5 months premature. And cow number 2 could have gotten rebred and had anothe entire pregnancy in just 5 months. So, either the calf in the pasture was some other cows twin, or it was cow 2 had the calf and it died. And now some other cow has calved , and cow 2 has stolen the other cows calf. Or is this just cow 2’s calf and she had nothing to do with the earlier dead calf. This is why pregnancy checking cows helps manage large and small herds alike
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.