Posted by Brent Zappe on January 24, 2019 at 09:10:13 from (104.192.91.181):
This is my final note to every body the work shop is done. Thank you every body for your information and support on the great advice you had shared. Sad to say now after spend a lot of money for a building it is time to seek more great knowledge. I am seeking to purchase tools. I was in a SNAP-ON tool book saw a wet sleeve puller (CG80A) Manuel puller but then looked and saw a Hydraulic wet sleeve puller. Which one would be the best to buy? How munch more is the Hydraulic puller and does it comes with the stuff to use it. Need to ask out here hey tractor friends do any body have extra tools you know might want to sell them? I really do not have a large amount of money after spending 107,000.00 on a three car garage unit. Yes that is right Wow I even have to say that is a lot of money but yes I live in California and that is way it coast an arm and a leg L.O.L. Just write back to me if you have any extra good tools. I forget I do have a John Deere 70 Diesel that I have to restore complete so any engine tools for it will help. Thanks Brent.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.