I'm answering way down here as I watch professionals gig George on a safety issue. On the older, non-condensing furnaces, the heat exchanger can crack BUT that doesn't mean you get co at deadly levels in the structure. Why? Because, like a fireplace, the 'draw' up the chimney pulls all gases and condensate outdoors. The largest Company in Des Moines had a scam (don't know what else to call it) wherein a person them called to get a furnace operating and the serviceman would do a 'free' checkup for a cracked exchanger. He'd get the furnace operating (usually a failed thermocouple) then have the homeowner go watch at a vent for smoke from his handheld smoke generator. He'd pull the filter out enough for the generator to get in the intake and the homeowner invariably yelled 'I see smoke'. The servicer would, if it was a lady, hug her and tell her 'you probably saved your Life'. And offer to replace that faulty furnace. Remember, this is going back about 40 years and the replacement costs for a furnace then was around $4000.00. Way too expensive for the average widow or pensioner. So, the servicer would say 'we have several good units at our shop that have been tested and cleaned and I think we can get one for you at $1500.00 installed. More often than not, the customer would jump on that deal. The customer got a 'new' (to them) furnace and THEIR old furnace went in to get cleaned along with a paint job to be re-sold. My in-laws used them for AC work--every year in the spring their central AC would run low on Freon and every year they'd have eight or nine pounds added. ON THE GAUGE. The whole system, if completely empty, had a capacity of nine pounds. They were being charged for that gauge which likely only meant two or three pounds actual liquid. I have a leak detector and found that the low pressure line was leaking at the condenser-next to where Freon is added. 1/2 turn and no more leak or yearly service call.
Upload one or more videos to your post. Photo and video filesizes should be less than 5MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
